Effect of Poor Power Factor The major effect of poor power factor is higher value of line current. We know that power factor (pf) is an important parameter for calculation of power in an AC circuit. For a given power and voltage, the current flowing through the line is inversely proportional to the power factor. This means that a poor power factor i.e. low power factor will result in hig...
Three-phase lines are common: three-phase three wire, three-phase four wire The three - phase three - wire system is star connection neutral point ungrounded and Angle connection method, the general high - voltage power supply uses three - phase three - wire system, three - phase four - wire is star connection neutral point grounding, low - voltage system uses three - phase four - wire system. &nb...
Due to the rapid development of power electronic technology, the nonlinear characteristics of industrial and agricultural power loads, especially transportation and civil electrical products are becoming more and more serious, and the power factor of users is also declining. Therefore, reactive power compensation devices are more and more widely used. The power compensation device is used to suppl...
What is power quality? The IEC (1000-2-2/4) standard defines power quality as follows: power quality refers to the physical characteristics of power supply devices that do not interrupt or interfere with users' use of power under normal working conditions. The most serious power quality problems are voltage sags and complete voltage interruptions. In fact, power quality refers to the...
Why is the harmonic current on the null line mainly three times? This is due to two reasons: (1) Among the harmonic components generated by single-phase rectifier circuit, the third harmonic is the largest, and the distortion rate of the third harmonic usually reaches more than 80%. (2) The harmonic current of other times will have the effect of canceling on the zero line, onl...
Effects of Harmonics : Increased losses Losses in capacitors The harmonic voltages applied to capacitors cause the flow of currents proportional to the frequency of the harmonics. These currents cause additional losses. Losses in conductors The active power transmitted to a load is a function of the fundamental component I1 of the current. When the current drawn by the load contains harmonics...
Electricity is a big part of our day, powering all the tech we use. There are two main types of electricity users, or "loads," called linear and non-linear. This just means they use electricity from the power supply in different ways. This distinction affects everything from power efficiency to the longevity of devices. Categories of Electrical Loads: · Inductive Loads: Characterized b...
Meaning Of Harmonics Harmonic refers to the electric quantity whose frequency is an integral multiple of the fundamental wave contained in the current. Generally, it refers to the Fourier series decomposition of the periodic non sinusoidal electric quantity. Except for the electric quantity of the fundamental wave frequency, the electric quantity generated by the current greater than the fundament...
Power Factor Correction Power Factor Correction improves the phase angle between the supply voltage and current while the real power consumption in watts remains the same, because as we have seen a pure reactance does not consume any real power. Adding an impedance in the form of capacitve reactance in parallel with the coil above will decrease Θ and thus increases the power f...
The inductor is a component that can convert electrical energy into magnetic energy and store it. The structure of the inductor is similar to that of a transformer, but there is only one winding, which only hinders the change of current. If the inductor is in the state of no current passing through, when the circuit is connected It will try to hinder the flow of current through it. If the inductor...
English
français
Deutsch
español
العربية
中文
IPv6 network supported
