Electricity is generated by generating stations and transmitted to load centers from where it is distributed to end consumers. These load centers are controlled by distribution utilities, and there is an inter-change of energy between different utilities connected to the grid. Consumers connected to the distribution utilities, though consuming active energy may or may not consume reactive energy. ...
YTPQC-AHF Active Harmonic Filter Based on the broad knowledge and experience in terms of solutions and applications in power quality, YT ELECTRIC has developed YTPQC-AHF Active Harmonic Filters. YTPQC Active Harmonic Filter is an active power correction solution to help stabilize electrical networks by providing harmonic mitigation and power factor correction, and load balancing. It is speci...
Why power factor is lower at power grid with solar? The active power and reactive power consumed by the system is fixed. When there is photovoltaic, photovoltaic provides active power, so the active power provided by the system decreases, and the reactive power remains unchanged, so the power factor decreases. If the active power provided by photovoltaics is close to the active power consumed by t...
We YT are the biggest manufacture of low voltage Static Var Generator and Active Harmonic Filter, all our factory take the quality as the most important positon. YT Incoming material Quality Control IQC check the raw materials, electronic components and enclosures from our suppliers before admitting to our warehouse. YT Process Quality Control In Process Quality Control, ...
What is the fault characteristics of power systems? In power systems, faults refer to abnormal conditions that occur due to equipment failures, environmental factors, or other disturbances. Faults can lead to disruptions in the electrical system, potentially causing equipment damage, system instability, or even blackouts. The fault characteristics in power systems include the following: Transients...
Installation Introduction of Static Var Generator SVG Modules: Step 1: Pre-Installation PreparationEnsure that the site is ready for the SVG module installation. Check if all necessary electrical connections and infrastructure are in place. Make sure you have the required tools and equipment for the installation. Step 2: Unpacking and Inspection Unpack the SVG module and carefully inspect i...
English
français
Deutsch
español
العربية
中文
IPv6 network supported
