Medium Voltage STATCOM for Mining Mining sites depend on stable medium voltage power. Crushers, conveyors, pumps, mills, hoists, compressors, and ventilation systems all place heavy demand on the electrical network. These loads do not always operate at a steady level. They start, stop, ramp up, and change throughout the day. This can create voltage fluctuation, poor power factor, and reactive powe...
Introduction: The High Cost of the "Invisible Killer" in July 2026 As we move further into the industrial energy transition of 2026, the reliance on diesel generators, gas turbines, and isolated microgrids remains a mission-critical reality for remote mining operations, large-scale agriculture, and telecommunication base stations. Yet, an "invisible killer" continues to bleed operational bu...
Three-Level AHF Stops Capacitor Failures in VFD Plants Capacitor banks can fail under VFD harmonic loads. Learn how a three-level active harmonic filter reduces THDi and supports capacitor-bank protection. A recurring VFD-plant problem looks like this: capacitor banks fail repeatedly even after replacement. The capacitors may not be the root cause. Nonlinear loads can inject 5...
A plastics extrusion plant in Ohio replaced motor starters with VFDs and cut drive energy use by 4%. Three months later, its 1000 kVA transformer ran 18 K above nameplate temperature, two capacitor banks tripped on overcurrent, and the utility applied a power-factor penalty. THDi on the 480 V bus measured 32% at full production. Adding capacitors would make that worse, not better. The fix i...
A 120 kW DC fast charger is not a resistive load, and ten of them are not ten kettles. When a highway charging hub starts a batch of charging sessions within the same minute, the transformer, cables and switchgear see a load profile closer to a small welding workshop than a retail site. The consequences—harmonic distortion, reactive power and three-phase imbalance—surface as tripped br...
English
français
Deutsch
español
العربية
中文
IPv6 network supported
