A plastics extrusion plant in Ohio replaced motor starters with VFDs and cut drive energy use by 4%. Three months later, its 1000 kVA transformer ran 18 K above nameplate temperature, two capacitor banks tripped on overcurrent, and the utility applied a power-factor penalty. THDi on the 480 V bus measured 32% at full production. Adding capacitors would make that worse, not better. The fix i...
Active Harmonic Filter Acceptance Test: 5 Critical Steps for Capacity Verification & Site Commissioning A purchase order does not prove that an Active Harmonic Filter will pass site acceptance. The project team must confirm what happens at the point of common coupling (PCC) when VFDs, rectifiers, welders, UPS systems, and capacitor banks operate together. Before acceptance...
Introduction: When the Protector Needs Protection Every facility manager knows the UPS is the last line of defense — the safety net that keeps critical operations alive when the grid fails or voltage sags. But there is an irony discovered only after equipment fails: the very load the UPS protects can quietly damage the UPS itself. Modern critical loads are almost always nonlinear. Rad...
A 120 kW DC fast charger is not a resistive load, and ten of them are not ten kettles. When a highway charging hub starts a batch of charging sessions within the same minute, the transformer, cables and switchgear see a load profile closer to a small welding workshop than a retail site. The consequences—harmonic distortion, reactive power and three-phase imbalance—surface as tripped br...
In modern industrial environments, automated manufacturing lines, variable frequency drives (VFDs), dynamic robotics, and heavy inductive loads have placed unprecedented demands on power distribution networks. . While investing in power quality equipment is vital to reduce downtime, avoid utility penalties, and improve energy efficiency, selecting the wrong solution can lead to costly equipm...
English
français
Deutsch
español
العربية
中文
IPv6 network supported
